Grape-Grape bud mite

Includes grape bud mite (Colomerus vitis)

Pest description and crop damage Grape bud mites are tiny (0.1 to 0.2 mm long), wormlike, and whitish yellow with two pairs of legs near the head. They can only be seen at magnification of 45 X or higher under a microscope, and the damage they cause is usually the first indication of their presence. The grape bud mite resides within the bud and causes damage by feeding on the preformed stem, leaf and flower primordia that exist within the bud. In spring, there may be no growth at all from damaged buds, or only weak shoots may grow from less damaged parts of the compound bud. Vines infested with bud mites may exhibit erratic budbreak, stunted shoots, malformed basal leaves, and have reduced number of flower clusters. Stunted shoots may have arrested development and fail to grow beyond a few inches. Damage is most visible on tissues rapidly growing during budbreak and up to 6 inches in length. Symptoms observed from mite feeding should not be confused with symptoms of nutrient deficiency (boron or zinc), low reserve carbohydrates, herbicide damage, frost, or thrips damage. There are distinct differences between bud mite-related damage and other factors.

Biology and life history Grape bud mites overwinter as adults inside buds where they feed on bud tissues and may kill the tissues within the overwintering bud. When buds begin to swell in spring, mites migrate to newly developing tissues where they feed and lay eggs. Eggs hatch and develop into adults. Bud mites move to the newly forming buds in the axils of the leaf petiole where they reside until budbreak the following year. During the next growing season, once growth commences, mites within the inner scales are distributed along the shoot length as the shoot develops. Those mites in the outer scales remain at the base of the shoot.

Sampling and thresholds Eriophyid mites are difficult to identify because of their microscopic size and translucent color. They reside in the buds for the majority of the year. Populations are assessed by examining buds on dormant canes in winter, using magnification of 45X or higher. A sample should consist of forty 1-year old shoots (canes) sampled randomly from affected areas in the vineyard. Select only the basal portions of the cane with at least three nodes. Place canes in a plastic bag and keep refrigerated until inspection. To look for mites in buds, use a dissecting microscope, and gently pull the outer bud scales off and work from the outside in, searching for the mites. To date, there are no damage thresholds known. However, if high populations are present in dormant buds, damage may have already been done, and spring control will reduce populations of bud mites for future years. While bud mites are different from rust mites, they look similar under magnification.

Management-chemical control: HOME USE

Dormant-season oils used for other pests may control this pest.

Management-chemical control: COMMERCIAL USE

The emergence of these mite species as pests of Pacific Northwest vineyards may be related to a general reduction in sulfur use to manage disease in some areas of Oregon and Washington. Sulfur continues to be used by organic growers and in many other Oregon vineyards as an economical way to control powdery mildew. Sulfur is effective to control pest populations of rust and erineum (blister) mites but may cause a decline in predatory mites when over-used. Chemical management of pest mites should be based on properly timed applications of sulfur.

-High-volume wettable sulfur (Microthiol Disperss, Kumulus DF, other brands). Check specific label for rate; apply at 100 gal water per acre. Make application at the woolly bud stage or during budbreak. A second follow-up spray is recommended approximately 7 to 10 days after the first, depending on weather conditions and growth rate, in order to target mites that were protected in unopened buds during the first spray application. High spray volume and timing are critical for targeting mites during migration and before they start producing eggs. Most brands are OMRI-approved for organic production.

-Use sulfur sprays in newly established vineyards. Typically young vines (years 1 and 2) are not sprayed as regularly as mature, producing vineyards, allowing mite populations to build during the growing season. Often more mites are found in these vineyard blocks, so it is best to apply sulfur during the growing season in young vineyards to control pest mite populations and powdery mildew.

For more information:

Grape Rust Mite